Flashing: What It Means on a Roofing Permit

The thin metal that seals every joint where water could get in, and one of the things inspectors check.

Updated November 2026 Glossary Term

Flashing: Thin metal or membrane material installed at roof joints, penetrations and wall intersections to direct water away from places where roofing or siding meet.

What Flashing Is

Flashing is the metal (or sometimes membrane) used wherever one surface meets another: where a roof meets a wall, around a chimney, vent or skylight, in a valley, at the roof edge and where a deck is attached to a house. Shingles shed water on a flat plane, but every joint is a place water can enter, and flashing is what covers it.

Common types include step flashing along sidewalls, a cricket behind a chimney, valley metal, drip edge at the eaves and rake, and pipe boots around plumbing vents. Valleys can be open metal or woven shingles, and each detail has its own installation rules from the manufacturer and the code.

Why Failures Cause Most Roof Leaks

Most roof leaks are not at the field of the shingles; they are at flashing that is missing, reused past its life or installed wrong. On a reroof, good practice is to replace flashing rather than bend the old pieces back, and to integrate it with the underlayment in the right order so water is always directed outward.

Flashing is also the detail that is hardest for the homeowner to judge, because once covered it cannot be seen. This is why photos and inspections matter. A good roofer will describe each flashing detail in the contract, and a homeowner can ask for pictures of the chimney, the sidewalls and the valleys before they are covered.

Flashing Beyond the Roof

Flashing matters on decks too. A deck attached to the house at a ledger board needs flashing over the top so water does not run behind the ledger and rot the rim joist. Windows, doors and chimneys also depend on it. The model residential code (IRC) calls for corrosion-resistant flashing at these locations, and inspectors look for it during the framing or final inspection.

Incompatible metals can corrode each other, so fasteners and flashing must be compatible with pressure-treated lumber, a detail that comes up on every attached deck. Chimney and skylight flashing is often built in layers, with step flashing under the shingles and counterflashing set into the masonry or the frame above.

Where Flashing Comes Up on This Site

Flashing is part of what a reroof permit covers, see the roof replacement guide. Our research on replacing a roof found 16 of 30 large cities exempt a like-for-like reroof and 14 require a permit for every one. On decks, see the deck permit guide and the deck threshold research, since attached decks are where ledger flashing comes up. Reroofing, new decks and window replacements all involve flashing, but the permit rules differ for each, so read the page for the project you are planning. Where a city requires an inspection, flashing is among the items on its list.

Frequently Asked Questions

Usually yes. Best practice is to install new flashing at walls, chimneys, valleys and penetrations when the roof is replaced, because old metal is often corroded or bent. Some cities and manufacturers require it. Ask your roofer to list flashing in the contract.
Water that runs behind a ledger board rots the framing that holds the deck to the house, which is a collapse risk. Flashing above the ledger directs water out and away. The inspector wants to see it installed before siding or trim covers it.
Sometimes, if it is sound and fits the new roofing, but it is often replaced. Rusted, bent or incompatible flashing can leak under a new roof, and replacing it is a small part of the cost compared with the repair if it fails. Your roofer or inspector can advise.
Stay up to date
Get notified when we add new cities or update permit fees.