Ice Barrier: What It Means on a Roofing Permit

The sticky membrane at the eaves that protects a roof from ice dams in cold climates.

Updated November 2026 Glossary Term

Ice Barrier: A self-adhering waterproof membrane installed along the eaves, valleys and other low points of a roof in cold climates to block water that backs up behind ice dams.

What an Ice Barrier Is

An ice barrier is a rubberized asphalt sheet with a sticky back, laid directly on the deck along the eaves before shingles go on. It is often sold as ice and water shield. Unlike ordinary underlayment, it seals around the nails driven through it, so meltwater that works up under shingles cannot reach the deck or drip into the house.

It is specified by the code for ice dam risk, not for ordinary leaks, though it is often also used at valleys, around skylights and chimneys. Roofers may quote it as a line item, because the rolls cost noticeably more than felt, and on a reroof you should ask how many courses they plan to install at the eaves.

Why Ice Dams Matter

In cold regions, heat escaping from the house melts snow on the upper roof. The water runs to the cold eave and refreezes, building a dam that forces more meltwater back up under the shingles. The leak shows up as stained ceilings, wet insulation and rot in the deck and wall tops.

The barrier is a backup. The lasting fix is air sealing and attic insulation and ventilation so the roof stays cold, which the local energy code addresses. A reroof is a good chance to check them. Ice dams are more likely on roofs with complex shapes, valleys, and heated spaces directly under the roof slope, such as vaulted ceilings.

When the Code Requires It

The model residential code (IRC) requires an ice barrier in areas with a history of ice forming along the eaves, extending from the edge up the roof to a point at least 24 inches inside the exterior wall line. Which towns count as ice-dam territory is a local decision, and many cities adopt, amend or list the requirement in their own roofing handout. Warm-climate cities usually do not require it at all. If your roofer proposes to skip it in a cold area, ask why, and look at whether the city's roofing handout lists it, since a reroof inspection may include it.

Because it goes on before the shingles and cannot be seen afterward, it is a typical item for an inspector or a contractor's photo.

Where Ice Barriers Come Up on This Site

An ice barrier is one of the details a reroof permit covers, described in the roof replacement permit guide and the project page. The roof replacement research compares when cities require a permit for a reroof at all: 16 of the 30 cities we cover exempt a like-for-like reroof, and 14 require one for every reroof. Cold-climate cities that require a permit usually list the barrier as part of the roofing standard.

Frequently Asked Questions

If you live where ice dams form, probably, since the model residential code requires one in areas with a history of ice along the eaves. Local adoption decides which areas count, so check your city's roofing requirements. Warm-climate cities usually do not require it.
The model residential code (IRC) calls for it to extend from the eave edge to a line at least 24 inches inside the exterior wall line of the building. On a wide overhang this can mean several courses of membrane. Local codes may modify this.
No. Ordinary underlayment is a general second layer under shingles. Ice and water shield is a self-adhering rubberized membrane that seals around nails and is used in the zones where water is most likely to back up. Many roofs have both.
Stay up to date
Get notified when we add new cities or update permit fees.