What Is a Ledger Board on a Deck Permit?

The board that bolts a deck to the house, and the most common reason attached decks fail inspection.

Updated November 2026 Glossary Term

Ledger Board: The horizontal board fastened to a house's frame that supports one side of an attached deck, held on with approved bolts or screws and covered with flashing to keep water out of the wall.

What the Ledger Does

A ledger board is the structural board that fastens one edge of a deck to the house. It carries a large share of the deck's weight and ties the deck to the house frame so the two move together. The other edge rests on posts and footings. If the ledger pulls away, the deck can fall, which is why attached decks have drawn so much attention from building departments.

The ledger is fastened to the house's rim joist or framing, not to siding, brick veneer or anything that is not structural.

On a house with brick veneer or a stucco finish the ledger often needs special detailing, because the fastener has to reach the framing behind it.

What Inspectors Check

Inspectors typically look at the ledger's size, the fasteners and their spacing, the flashing and the framing it attaches to. Model residential code details call for through-bolts or structural lag screws in a staggered pattern, and not nails. Flashing is installed above and behind the ledger so water does not run into the wall and rot the rim joist.

Details such as washers, spacing and edge distances vary by code edition and city. The plan examiner's handout may show an approved detail you can copy.

Inspectors also look for rot or damage in the existing rim joist before the ledger covers it.

Attached vs. Freestanding Decks

A freestanding deck stands on its own posts and does not use a ledger, so it avoids the issues of attachment and wall flashing. Some cities treat freestanding decks differently for permit exemptions or setbacks. The tradeoff is that you need extra posts and beams along the house side.

If you are unsure which approach fits your lot, our deck permit thresholds research compares how 30 cities treat attached and freestanding decks.

Freestanding decks may still be subject to guard, footing and size rules, so avoiding a ledger does not necessarily avoid a permit.

Where Ledgers Come Up on This Site

Ledgers are the key item in deck reviews. The deck permit page and deck permit guide explain what plans to submit, and the deck permit fees research compares cost. Whether your deck needs a permit at all varies by city, and attached decks are usually the ones that do.

See footing for the other major inspection.

Many cities publish a deck handout with an approved ledger detail, and our city pages link to the department's own documents where they exist. If your plan follows the handout, review is usually quicker than if you design your own connection.

Frequently Asked Questions

An attached deck normally uses a ledger, but alternatives exist, such as a freestanding structure with its own posts and beam next to the house. Cities vary in how they treat each, so check your city's rules and your permit review comments for the approved method.
Model residential code details call for structural through-bolts or approved lag screws set in a specified pattern, not common nails. The exact pattern depends on the joist size and span, and local rules or the plan examiner's handout supply the approved detail you should follow.
Water that gets behind the ledger can rot the house's rim joist and wall framing over time, hiding damage that weakens the connection. Flashing sheds water away from the wall. Inspectors check it because the damage is concealed and expensive once the deck is already built.
Stay up to date
Get notified when we add new cities or update permit fees.