Amperage: What Panel and Service Size Mean

The number of amps on your panel label that sets how much power the whole house can draw at once.

Updated November 2026 Glossary Term

Amperage (Service Size): The measure of electrical current, in amps, that a panel and service are rated to carry. Homes commonly have 100, 150 or 200 amp service, and permits often price and review work by that number.

What the Number Means

An amp measures the flow of current. A panel's amperage rating is the ceiling on what the main breaker and the bus bars can carry together. Think of it as the width of the pipe: a 100 amp service passes less total power than a 200 amp service, even though both deliver the same voltage. Your amperage is on the main breaker handle and the panel label, and the meter base and service wires have to be sized to match. When a permit form asks for existing and proposed service size, this is the number it wants, and an inspector will compare it with what is on the panel and the permit.

Why Homeowners End Up Needing More

Older homes often have a 60 or 100 amp service sized for lighting and a few appliances. Adding an electric vehicle charger, heat pump, electric range, hot tub or a second story can add loads that do not fit. A reviewer or electrician runs a load calculation under the National Electrical Code, which adds up the connected loads using standard demand factors and shows whether the existing service passes. If it does not, the answer is a larger service or load management.

How Amperage Affects Permit Fees

Many cities tie the fee to the service size. In the electrical panel fee comparison, nine of 30 cities price the permit by amperage, eleven charge one flat fee at any size, six price on the job's value and four add up itemized components. The city's own 100 to 200 amp upgrade fee runs from $57 in Baltimore to $450 in San Francisco, with a median of $108. These are the city's own figures; the electrician's price is separate. If your city prices by amperage, a bigger service can raise the permit fee a little, but the fee is rarely the main cost of the upgrade.

Amperage vs. Voltage vs. Watts

Amps are not the same as volts or watts. Household circuits are 120 or 240 volts, and watts are volts times amps. When an inspector asks about the rating of a breaker or a charger, they mean amps. See the electrical service entry for how the rating fits into the whole connection, and the dedicated circuit entry for a single appliance's share. Watts, volts and amps relate by a simple formula: a 240-volt, 40-amp circuit can supply up to 9,600 watts, and the National Electrical Code adds margin for loads that run continuously, such as car charging.

Frequently Asked Questions

Many modern homes have 200 amp service, and 100 amp is common in older ones. The right size depends on connected loads, not square footage alone, so electric heat, an EV charger or a pool may require more. A load calculation is what the permit office and electrician rely on to decide.
Yes in nearly every jurisdiction, since it changes the service equipment, and the utility will want an inspection before reconnecting power. Fees and who may apply vary by city, and the electrical panel research compares both city by city.
No. The main breaker and the wire behind it must match, and individual circuit breakers must match their own wire. Swapping a breaker for a larger one without changing the wire is a fire hazard, and an inspector will fail it. A tripping breaker usually means an overloaded or faulty circuit.
Stay up to date
Get notified when we add new cities or update permit fees.