Heat Pump: What It Means on a Permit

One outdoor unit that both heats and cools, and the reason a swap often touches two permits.

Updated November 2026 Glossary Term

Heat Pump: An electric system that moves heat in or out of a home using refrigerant, so one outdoor unit and one indoor coil or air handler provide both heating and cooling.

What a Heat Pump Is on a Permit Form

Permit forms rarely say heat pump on its own line. You will see it as HVAC replacement, mechanical equipment change-out or a box for condenser, air handler or furnace. A heat pump counts as mechanical equipment because it moves refrigerant and air, so the work falls under the same mechanical permit that covers a furnace or central air conditioner.

It also draws a lot of electricity, which is why the form may ask for the breaker size, the disconnect and the wire. The city is checking that the new unit is sized for the house, sits where the code allows and is wired safely. A heat pump replacing central air with a gas furnace inside may also appear as two lines on the form, one for the outdoor unit and one for the indoor coil or air handler, and both belong to the same job.

Why a Swap Often Means Two Permits

Replacing an air conditioner with a heat pump is usually a like-for-like change on the mechanical side, but the electrical side can change: heat pumps often use a different breaker size, and many include electric backup heat strips that add load. When the circuit or the disconnect changes, the work may need an electrical permit too.

Some cities fold both into one HVAC permit; others issue them separately, sometimes to different license holders. Check the permit page for your city before you assume the installer's quote covers both, and ask who will pull each permit, because the person named on the permit is the one responsible for passing the inspection.

What Inspectors Look At

On a heat pump install the inspector typically checks the outdoor unit location and clearances, the pad or stand, the refrigerant line set, the condensate drain, the electrical disconnect and the connection to the existing ductwork. If the old equipment was a gas furnace, the removal of the flue and the cap on the gas line are checked as well.

Code compliance for energy efficiency, such as minimum efficiency ratings and duct leakage, comes from the local energy code, which varies by state and city. Many cities also expect the installer to show the equipment's model and capacity on the permit so the reviewer can confirm it matches the load the house needs.

Where Heat Pumps Come Up on This Site

The research page on replacing a furnace or AC found that a like-for-like swap of a central AC or heat pump needs no permit in only 3 of the 30 largest U.S. cities we cover, and a permit in 24. Its companion on HVAC permit fees reports the city's own figure for a permitted single-unit change-out, from $39 to $315 with a median of $105. Our HVAC permit page and HVAC guide walk through the steps.

Frequently Asked Questions

In most large cities, yes. Our research found that only 3 of 30 cities exempt a like-for-like AC or heat pump swap, and 24 permit every one. A few cities treat it differently depending on the equipment, and one lets the contractor certify the work. Your city's permit page decides, so check it before ordering equipment.
Sometimes. If the breaker, wiring or disconnect stays the same, many cities treat it as a mechanical change only. If the new unit needs a bigger circuit or electric backup heat, an electrical permit may be required. Some cities bundle both into a single HVAC permit, so ask which applies.
That depends on the city. Our research found 15 of 30 cities let an owner-occupant pull the HVAC permit, 10 allow it only in part or after a test, and 5 want a licensed contractor only. Refrigerant handling also requires federal certification, which limits what a homeowner can legally do on the sealed system.
Stay up to date
Get notified when we add new cities or update permit fees.