Energy Code: The part of a building code that sets minimum energy efficiency rules for new and altered buildings, covering insulation, windows, air sealing, ducts, lighting and sometimes heating and cooling equipment.
What an Energy Code Regulates
An energy code sets minimums for how much heat a building loses or gains and how efficiently it is heated and cooled. It addresses insulation in walls, attics and floors, window performance, air leakage, duct sealing, lighting and, in some places, equipment efficiency. Requirements usually vary by climate zone.
Most states base theirs on the International Energy Conservation Code; California uses Title 24.
Some provisions are mandatory, and others let you choose a path, such as meeting a prescriptive table or showing equivalent performance with a calculation.
The same code is also where lighting and mechanical ventilation requirements are often found.
What Triggers It on a Remodel
Energy rules apply to new construction and additions, and many cities apply them to the altered part of a remodel. Replacing windows, opening walls, adding an attic hatch, installing or replacing HVAC and re-roofing can each pull in a requirement. Straight repairs are usually exempt, but what counts as a repair is a local decision.
The permit office or its checklist says whether energy compliance is part of your application.
If you are unsure whether your job counts as a repair or an alteration, ask the permit office before ordering materials.
Replacement work that changes the system, such as moving ductwork or adding a new unit, is more likely to bring in requirements than a like-for-like swap.
What Reviewers and Inspectors Ask For
Reviewers may ask for a compliance form, window ratings, insulation values or an equipment efficiency sheet. Inspectors check insulation before it is covered and may ask for window labels or a duct test result. If the work is simple, the form may be a one-page checklist.
See HERS rating and testing for the third-party tests some places require.
For routine jobs the application itself may state that energy compliance is met by listing the equipment efficiency or window label, so the paperwork is short.
Where the Energy Code Comes Up on This Site
It touches HVAC, window, roof and addition permits. Our HVAC replacement rules research shows how cities treat a furnace or AC swap, and the home addition guide covers the plans an addition needs.
Because energy rules are adopted locally, the figures differ by city; use the city page rather than a national table.
Efficiency ratings such as SEER2 are the usual numbers on equipment sheets, and the equipment label is what the reviewer checks.
If a city treats energy work separately, its own page says so.