Structural Calculations: Written engineering calculations, usually by a licensed engineer, showing that beams, headers, footings or connections can safely carry the loads they will see. Cities request them when a design falls outside the standard code tables.
What They Are
Structural calculations, often shortened to calcs, are the engineer's worked math: the loads on a member, the span, the size and grade of lumber or steel chosen, and the connection details. The result usually appears on the drawings as a beam size or a note, with the full calculations attached as a packet or a letter.
The reviewer reads them to confirm the design meets the structural provisions of the adopted building code.
A good rule is to ask what the member is carrying. If the answer is a roof, a floor above or a long span, expect calculations unless the code tables clearly cover it.
When a Permit Asks for Them
Model codes include prescriptive tables that let builders size common members without engineering. Calculations are requested when the design leaves those tables: a long span, an unusually heavy load, a removed wall, a second-story addition or a custom foundation. Removing a load-bearing wall is the classic homeowner case, because a new beam has to replace what the wall carried.
Many cities also want them when the project sits in a high-wind or seismic area.
Calculations usually come as a few pages with the engineer's seal, a list of assumptions and the loads used. A reviewer will compare those assumptions with your plans, so details must agree.
What It Changes for You
Calculations mean an engineer is involved, which adds cost and time before you apply. The engineer's stamped letter or packet is submitted with the plans, and the city may ask for corrections. If a contractor says the beam size is just standard, ask whether the city will want calcs; a missing packet is a common reason for an application to be returned.
See stamped plans for how the engineer's seal fits in.
Contractors sometimes size beams from supplier span tables. Many cities accept that only for standard conditions, so confirm before you order, because a beam purchased without approved sizing can be costly to replace.
Where It Comes Up on This Site
Our kitchen remodel triggers comparison and bathroom remodel comparison show how often walls and structure move a job into a building permit. The home addition guide covers the engineering side of larger projects.
These comparisons also show that moving a wall or a fixture is where permits typically begin. Calculations belong to the structural end of that range, rather than the cosmetic end. Ask the building department's counter staff which kinds of members need a seal, since the answer is local.